WiFi Connected But No Internet on Windows 11? 10 Fixes That Work
Your laptop says it's connected to WiFi. Full signal bars. And yet nothing loads — no websites, no apps, just that little globe icon and the words "No internet, secured." It's one of the most annoying things that can happen on a Windows 11 PC, and it happens to millions of people.
The good news: in most cases, you can fix it yourself in about ten minutes. The trick is to diagnose first and fix in order — start with the simplest causes, and only move to the bigger resets if the simple ones don't work. This tutorial walks you through exactly that, in the order worth trying.
If your WiFi keeps dropping instead, see WiFi Keeps Disconnecting on Windows 11? 8 Fixes That Work.
First, Find Out Where the Problem Is (30 Seconds)
Before you touch a single setting, grab your phone and check: is it online on the same WiFi?
- Your phone is offline too: the problem is your router or your internet provider, not Windows. Skip to the "What If No Device Has Internet?" section at the bottom — no amount of Windows fixing will help.
- Your phone works fine, only the PC is offline: the problem is on your Windows 11 PC. Work through the fixes below, in order, and stop as soon as pages load again.
That one check saves you from wasting an hour fixing the wrong thing.
Fix 1: Restart Your Router and Modem the Right Way
Yes, the classic "turn it off and on again." It sounds too simple, but a router restart clears the majority of these cases — a stale connection between your router and your provider is the single most common cause.
Do it properly, though. Don't just press the power button:
- Unplug both the modem and the router from the wall.
- Wait a full 30 seconds. This matters — it lets the hardware fully discharge.
- Plug the modem back in first and wait until its "online" light goes solid (usually 1–2 minutes).
- Then plug the router back in and wait another minute.
- Reconnect your PC to WiFi and test.
If pages load, you're done. If not, move on.
Fix 2: Turn WiFi Off and Back On, Then Forget and Reconnect
A temporary glitch in the wireless connection itself can cause this. First, the quick version: click the network icon on the taskbar, turn WiFi off, wait 10 seconds, and turn it back on.
If that doesn't help, make Windows forget the network entirely and reconnect from scratch:
- Open Settings → Network & internet → Wi-Fi.
- Open Manage known networks.
- Find your network, click it, and choose Forget.
- Reconnect to the network and type the WiFi password again.
Make sure you know the WiFi password before you do this — you'll need it to get back on.
![]() |
| Settings - Manage known networks |
Fix 3: Run the Windows Network Troubleshooter
Windows 11 has a built-in troubleshooter that can spot common problems on its own. It's worth running before you start typing commands:
- Open Settings → System → Troubleshoot → Other troubleshooters.
- Find Network Adapter and click Run.
- Follow whatever it suggests. (On newer Windows 11 builds, the troubleshooter lives in the Get Help app — search for "network troubleshooter" there.)
If it finds and fixes something, great. If it reports nothing wrong, keep going.
Fix 4: Release and Renew Your IP Address
Your PC gets an IP address from your router (via DHCP). Sometimes that address goes stale or conflicts with another device, and Windows ends up "connected" to the router but with no working route to the internet. Releasing and renewing it takes thirty seconds:
- Right-click Start and open Command Prompt (Admin) or Windows Terminal (Admin).
- Type
ipconfig /releaseand press Enter. - Type
ipconfig /renewand press Enter. - Try loading a website.
Fix 5: Flush the DNS Cache
DNS is what turns "google.com" into an address your PC can reach. A corrupt DNS cache can leave you connected to WiFi while every website fails to load. Clearing it is harmless and instant:
- In the same administrator Command Prompt window, type
ipconfig /flushdnsand press Enter. - You should see "Successfully flushed the DNS Resolver Cache."
- Try loading a website again.
Fix 6: Reset Winsock and the TCP/IP Stack
If renewing the IP and flushing DNS didn't help, the Windows networking components themselves may be corrupted. These two commands reset them:
- In Command Prompt (Admin), run:
netsh winsock resetnetsh int ip reset - Restart your PC. The reset only takes effect after a restart.
- Reconnect to WiFi and test.
This is safe — it resets network settings to defaults, it doesn't touch your files.
![]() |
| Command Prompt - ipconfig commands |
Fix 7: Change Your DNS Server
Sometimes the problem is your provider's DNS server: it stops responding, and suddenly no website resolves even though you're "connected." Switching to a free public DNS is one of the fastest permanent fixes:
- Open Settings → Network & internet → Wi-Fi, then click your network's Properties.
- Find the DNS server assignment (or go via Control Panel → Network and Sharing Center → Change adapter settings, right-click your WiFi adapter → Properties → Internet Protocol Version 4 (TCP/IPv4) → Properties).
- Select Use the following DNS server addresses and enter:
Preferred:8.8.8.8(Google) or1.1.1.1(Cloudflare)
Alternate:8.8.4.4(Google) or1.0.0.1(Cloudflare) - Click OK, disconnect and reconnect to WiFi, and test.
If websites suddenly load, your provider's DNS was the culprit. You can leave the public DNS in place permanently — it's free and widely used.
![]() |
Fix 8: Disconnect Your VPN and Check Proxy Settings
VPNs and proxy settings reroute your traffic. If the VPN server is down, misconfigured, or blocking your connection, Windows will show "connected" while nothing gets through.
- Disconnect your VPN completely and test. If the internet comes back, the VPN was the problem — update it or switch servers.
- Check your proxy: Settings → Network & internet → Proxy. If a proxy is turned on and you didn't set it yourself (or your workplace didn't), turn it off and test.
Note: if you're on a work or school network, don't change proxy settings without checking with IT first — they may be required.
Fix 9: Update or Reinstall Your WiFi Driver
A buggy or outdated wireless driver can cause exactly this symptom, especially after a Windows update. Updating it is straightforward:
- Right-click Start and open Device Manager.
- Expand Network adapters, right-click your WiFi adapter, and choose Update driver → Search automatically for drivers.
- If Windows says you already have the best driver, try the laptop manufacturer's website instead — search for your exact laptop model + "WiFi driver" and install the latest one from there.
- If updating doesn't help, right-click the adapter in Device Manager, choose Uninstall device, restart your PC, and let Windows reinstall the driver automatically.
Fix 10: Reset Network Settings (Last Resort)
If nothing above worked, Network Reset wipes all network adapters and settings and reinstalls them fresh. It fixes stubborn cases — but it also deletes your saved WiFi passwords and VPN settings, so only use it last:
- Open Settings → Network & internet → Advanced network settings.
- Select Network reset → Reset now.
- Your PC will restart. After that, reconnect to WiFi with your password and set up your VPN again if you use one.
If the internet still doesn't work after a network reset, the problem is almost certainly hardware (a failing WiFi card) or your provider — time to call your ISP or a repair shop.
What If No Device Has Internet?
If your phone is offline on the same WiFi too, stop fixing Windows — the problem is upstream:
- Check the cables between your modem, router, and the wall socket. A loose cable is embarrassingly common.
- Check your provider's outage page or app (from your phone's mobile data) to see if there's a known outage in your area.
- Try a wired connection: plug an Ethernet cable from the router directly into your laptop. If wired works but WiFi doesn't, the router's WiFi radio is the problem.
- If nothing works, call your internet provider. Tell them you've already restarted the modem and router — it saves ten minutes of scripted questions.
Frequently Asked Questions
Why does Windows say "No internet, secured"?
"Secured" only means your WiFi connection is encrypted — it's not a guarantee of internet access. Windows runs a connectivity check in the background; when that check fails, it shows "No internet" even though you're connected to the router.
Will Network Reset delete my files?
No. It only removes network adapters, saved WiFi networks, and VPN settings. Your documents, photos, and apps are untouched. You will need your WiFi password to reconnect afterwards, though.
Why does WiFi work on my phone but not my laptop?
Because the two devices take different paths. Your phone talks to the router and out to the internet fine; your laptop's problem is somewhere between Windows and the router — usually a stale IP address, a DNS problem, or a driver issue. Fixes 4 through 9 above target exactly that.
How do I know if it's my router or my PC?
The phone test at the top of this article. If every device is offline, it's the router or provider. If only the PC is offline, it's the PC.
The Bottom Line
Most "WiFi connected but no internet" cases on Windows 11 are fixed by one of three things: a proper router restart, releasing and renewing your IP address, or switching to a public DNS server. Work through the fixes in order, stop as soon as you're back online, and save the network reset for last. And if every device in the house is offline — that's not a Windows problem at all, it's your router or your provider.


